To Replace A Tape Cartridge Magazine; Hot Swappable Crus; Drive Tray Assembly - Oracle StorageTek SL150 Manual

Hot Swappable CRUs

Pull the magazine free of the module and set it aside.
3.

To Replace a Tape Cartridge Magazine

Orient the magazine with the cartridge slots facing toward the center of the
1.
module.
Lift the magazine and point the back of it toward the module slot.
2.
Engage the magazine with the track in the magazine bay of the module.
3.
Verify all tapes are properly seated in the magazine slots.
4.
Push the magazine fully into the library module.
5.
From the Library list, select Lock and Audit.
6.
Select the Set the Library back online after applying this action check box in the
7.
Lock and Audit dialog box.
Click OK.
8.
Hot Swappable CRUs
This section provides removal and replacement instructions for the tape drive tray and
power supply CRUs that you can replace while power is applied to the library. You
temporarily remove the power supply or drive tray assembly and then insert the
corresponding CRU in the open slot.

Drive Tray Assembly

The drive tray assembly (drive tray) is located in the center, rear of the module (see
Figure
an exposed circuit card near the right side thumbscrew, a tape drive, and a chassis
(also referred to as a sled).
3-6 StorageTek SL150 Modular Tape Library Customer Replaceable Unit Guide
Although the magazine contains cartridge retention
Caution:
springs, use care when holding or moving the magazine to avoid
unseating or dropping cartridges.
Code levels before 2.25 do not have the Lock and Audit
Note:
command.
Do not operate the library with open tape drive or
Warning:
power supply slots.
3–1). The drive tray has a series of indicators on the back panel (see Figure 3–8),