Digi Navigator Application; Configure Realport From The Digi Navigator - Digi IX10-00G4 User Manual

Serial port
8. Click Download to download the serial port log.
9. (Optional) For Log size, configure the maximum allowed log size for the serial port log. The
default is 65536.

Digi Navigator application

You can use the Digi Navigator application with the IX10 device to discover device IP addresses,
install and configure RealPort, and verify connection to the network.
Before you begin
Your device must be
after it has been installed.
Use the Digi Navigator application features
These features can be performed from the Digi Navigator.
Configure RealPort
n
Discover the device's IP address
n
Install and configure the Digi Navigator application
Install the Digi Navigator
n
Connect to and access the Digi Navigator
n
Digi Navigator features
n
Discover the IP address when connected to a network
n
Discover the IP address when not on a network
n
Manage the RealPort device list
n
Access the web UI from the Digi Navigator
n
Filter devices for display in the Digi Navigator
n
Access Digi Remote Manager from the Digi Navigator
n

Configure RealPort from the Digi Navigator

You can configure the IX10 to communicate with your computer using RealPort from the
Navigator. You must enable RealPort on the device and then configure your computer for RealPort.
In this step, all serial ports on the device are set to RealPort mode and the RealPort service is enabled.
The COM ports on your laptop are also configured.
Note You can also configure the device to accept a Realport connection from the web UI on the
device. See Configure RealPort
1. Make sure theIX10 is
2. Download and install
3. Launch the Digi Navigator.
4. Select the device you want to configure using one of the following methods:
IX10 User Guide
connected to your network or a laptop
mode.
powered on and connected to your network or
the Digi Navigator.
Digi Navigator application
before you can access the Digi Navigator
computer.
Digi
196