Working With Profinet/Profisafe F-Devices - ABB AC500-S Safety User Manual

Fig. 64: Permissions for user and user groups

4.3.4 Working with PROFINET/PROFIsafe F-Devices

You have to install GSDML files to be able to configure 3
In order to use 3
PROFINET and support the PROFIsafe bus profile in V2 mode
all (safety and non-safety) PROFINET devices is the specification of the device in the GSDML
file (generic station description markup language).
I/O device properties are saved in the GSDML file. For PROFINET/PROFIsafe devices, portions
of the GSDML file data are protected by a CRC
manufacturers.
2020/06/19
System configuration and programming > Working with PROFINET/PROFIsafe F-Devices
DANGER!
It is the responsibility of project administrator to setup a proper user manage-
ment for the given safety application project to avoid unauthorized access to
safety modules.
Passwords for users with safety group membership shall be properly selected
(at least 8 symbols are recommended with a combination of numbers and let-
ters). An access to passwords must be strictly controlled.
Make sure that you set "Deny" permission for proper users and groups (e.g.,
Everyone) through menu "Project è User Management è Permissions..." to
avoid unauthorized creation of new users in the safety group.
rd party F-Devices with AC500-S safety PLC, the safety devices must be on the
NOTICE!
Please contact ABB technical support for details on supported GSDML file ver-
sions. It depends on the version of your installed Automation Builder.
3ADR025091M0208, 12, en_US
Configuration and programming
rd
party PROFIsafe F-Devices.
Ä [3]. The basis for configuring
Ä [3]. GSDML files are supplied by the device
131