ABB AC500-S Safety User Manual page 386

Usage of safety CPU with V3 non-safety CPU PM56xx
Severity
2
2
2
2
2
2
2
2
2
2
2
3
3
3
3
3
3
3
3
386
Error code Description
8721 Internal error
8722 Internal error
8723 Checksum error has
occured in Safety PLC
8729 Internal error
8741 Cycle time error in Safety
PLC
8742 Internal error
8746 Internal error
8747 Internal error
8756 Internal error
8758 Internal error
8990 PROFIsafe configuration
error
12561 Safety source addresses
cannot be checked
12570 Error in configuration data,
Safety PLC cannot read
configuration data
12571 Error in configuration data,
Safety PLC cannot read
configuration data
12598 PROFIsafe F_Dest_Add
rules are violated
32770 Watchdog error coupler
32771 Wrong firmware version of
Communication Module
32772 Initialisation of Safety
Module on slot failed.
More than one Safety
Module plugged
32774 Invalid configuration data
3ADR025091M0208, 12, en_US
Remedy
Contact ABB technical support.
Replace Safety PLC.
Contact ABB technical support.
Replace Safety PLC.
Restart Safety PLC. If this error
persists, replace Safety PLC.
Contact ABB technical support.
Replace Safety PLC.
Check Safety PLC watchdog
time.
Contact ABB technical support.
Replace Safety PLC.
Contact ABB technical support.
Replace Safety PLC.
Contact ABB technical support.
Replace Safety PLC.
Contact ABB technical support.
Replace Safety PLC.
Contact ABB technical support.
Replace Safety PLC.
Check F-Parameter configura-
tion of I/O module and reload
boot project
Check PROFIsafe F-Host
library version (2.0.0 or above).
If this error persists, contact
ABB technical support.
Create new configuration data
Create boot project
Check Safety PLC configuration
or switch address setting
against PROFIsafe
F_Dest_Add configuration
rules. Restart Safety PLC. If this
error persists, contact ABB
technical support.
Update firmware
Remove this module or Only
that one Safety Module plugged
-> defective, replace this
module
Check configuration
2020/06/19