ABB AC500-S Safety User Manual page 210

Configuration and programming
AC500-S libraries > SafetyBlocks_PLCopen_AC500_v22.lib
Table 29: FB-specific status codes (no error):
DiagCode
0000
8005
8000
8004
4.6.4.5 SF_EmergencyStop
Standards Requirements
EN 418:1992 3. Definitions
4.1.12 ... Resetting the control device shall not by itself cause a restart command.
EN 954-1:1996 5.4 Manual reset
ISO 12100-2:2003 4.11.4 Restart following power failure/spontaneous restart
IEC 60204-1, 9.2.2. Stop Functions
Ed. 5.0:2003
210
State name State description and output setting
Idle The function block is not active (initial state).
Ready = FALSE
Error = FALSE
S_AnyModeSel = FALSE
All S_ModeXSel = FALSE
Mode- State after activation or when S_ModeX has changed (unless
Changed locked) or after reset of an error state.
Ready = TRUE
Error = FALSE
S_AnyModeSel = FALSE
All S_ModeXSel = FALSE
ModeSe- Valid mode selection, but not yet locked.
lected
Ready = TRUE
Error = FALSE
S_AnyModeSel = TRUE
S_ModeXSel = Selected X is TRUE, others are FALSE.
ModeLocked Valid mode selection is locked.
Ready = TRUE
Error = FALSE
S_AnyModeSel = TRUE
S_ModeXSel = Selected X is TRUE, others are FALSE.
3ADR025091M0208, 12, en_US 2020/06/19