Vertiv NetSure LMS1000 User Manual page 76

System configuration files can be saved on disk, or loaded back into a system using the DOWNLOAD and
UPLOAD commands, as described below. These commands are also described in the "Commands" section.
These commands are available to users programmed for access to level 6 commands.
To Download the Configuration from the LMS1000 to a PC using XMODEM:
1. Log on to the system. The user must have access to level 6 commands.
2. Enter the command
You have up to 1 minute to initiate a file transfer.
3. The system will wait up to 1 minute before aborting the process if no file transfer occurs. The system
waits for a 'C' character, which is the synchronization character for starting an XMODEM CRC file
transfer.
4. At the PC, initiate a file transfer using XMODEM CRC protocol.
To Upload a Configuration from a PC to the LMS1000 using XMODEM:
1. Log on to the system. The user must have access to level 6 commands.
2. Enter the command
following will be displayed.
UPLOAD using XMODEM Protocol with CRC error checking
You have up to 1 minute to initiate a file transfer. Each second during this 1 minute period the
system sends a 'C' character, which is the synchronization character for starting an XMODEM CRC
file transfer.
3. At the PC, initiate a file transfer using XMODEM CRC protocol.
4. When the transfer is complete, the following is displayed.
84 blocks received OK.
Upload Complete.
The number of blocks received may vary.
NOTE!
If an error message (as shown below) appears, the file being uploaded must be re-edited to
correct the appropriate program line. The CLR PROG command may be used instead of re-editing the
upload file. Refer to the CLR PROG command in the COMMANDS section.
202 blocks received OK.
R01=h1
^
Program error -- Bad Character
Upload Complete.
Vertiv™ | NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
DOWNLOAD DOWNLOAD NETSURE
, or
UPLOAD UPLOAD NETSURE
, or
DOWNLOAD NPS
, or
UPLOAD NPS
, or ; then press
ENTER
; then press .
ENTER
. The
76