Table of Contents
Advertisement
SET-ATTRIBUTE-ENVIRONMENT
(SET-ATTR-ENV)
Referenced In: TR-NWT-000833, Issue 5, pg. 4-395
General Description: Instructs LMS1000 to set the current attributes associated with the specified
environmental alarm.
An entry is made in the LMS1000's event log indicating this command was executed by the current user.
Related Commands: RETRIEVE-ATTRIBUTE-ENVIRONMENT
LMS1000 Access Level: 6
An error response with the error code PICC is returned if this command is entered by a valid user whose level of
access is less than the access level of this command.
LMS1000 Equivalent: None
LMS1000 Input Format Variations:
<aid>
The access identifier (<aid>) parameter identifies equipment associated with the environmental alarm for which
attributes are being set. A NULL value is not permitted for this parameter. Invalid values received for this
parameter return an error response with the error code IIAC.
<ntfcncde>
Specifies the value for the notification code parameter associated with the environmental alarm conditions
being set. Parameter grouping cannot be used with this parameter. This parameter is an attribute of the
LMS1000 channel or limit configuration and is required in the input.
Valid values for this parameter are as follows:
CR
critical alarm
MJ
major alarm
MN
minor alarm
NULL
leaves <ntfcncde> unchanged
Invalid values for this parameter return an error response with the error code IDNV.
<almtype>
Specifies the alarm type parameter associated with the attribute being set. Parameter grouping cannot be used
with this parameter. Values are derived from the CONDITION TYPE attribute of the LMS1000 channel or limit
configuration. This parameter is required in the command input. The error code for an invalid value for this
parameter is IDNV.
<almmsg>
This parameter is not implemented in LMS1000. A NULL value leaves the <almmsg> parameter unchanged,
and is the only value which is accepted. Parameter grouping cannot be used with this parameter. Invalid values
for this parameter return an error response with the error code INUP.
LMS1000 Response Format Variations: None
Vertiv™
| NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
498
Advertisement
Table of Contents
