Table of Contents
Advertisement
CLR POWER <n>
CLR PROGRAM <tn>
CLR RLY <n>
CLR STATS <tn>
IP ADDRESS <address>
IP DELETE <address>
IP GATEWAY <address>
IP HOST <address>
IP NETMASK <netmask>
NETWORK INITIALIZE
NODE ADD
NODE CONFIG <n>
NODE DELETE <n>
NODE INITIO <n>
NODE LIST <n>
NODE REPLACE <n>
SET ACO
SET AID <n>
SET ANSWER <n>
SET CHANNELS
SET CLASS <n>
SET CMD <n>
SET COM
SET DATE <mm/dd/yy>
SET DEFAULTS
SET EFF
SET EMAIL
SET GATEWAY
SET INFO <n>
SET LED <n>
SET LIMITS <tn>
SET NPS
SET MAIL
SET MODE
SET PERIODS <tn>
SET PHONE
SET PROGRAM <tn>
SET REPORT
SET RLY <n>
SET STATS CHANNELS
SET SEQUENCE
SET STATUS <n>
SET SYSTEM
SET TIME <hh:mm:ss>
SET TIMEOUT <n>
SET UNIT
Vertiv™
| NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
clear power consumption data
clear control programs
de-energize relay
clear channel statistics
set the units IP address
remove a host from the list of authorized hosts
set the units gateway address
add a new host to the list of authorized hosts
set the units network netmask
clear all known nodes and search for new nodes
search for and configure new nodes
configure user information for a node
remove a node
reinitialize a node's I/O hardware configuration
view user and hardware configuration for nodes
replace a node
cutoff present alarms from affecting relays
configure access identifier
set number of rings before the system answers
set user defined channels
set programmable alarm classifications
set programmable commands
set local comm port configuration
set date where mm = month, dd = date, yy = year
set system default parameters
set Energy Management parameters
set IP DNS server, SMTP Server, and return mail addresses
set GATEWAY port communications data rate
configure information pages
turn LED on
set channel alarm limits
set NPS parameters
send mail to users
modify configuration of TL1 port settings
set time periods
set user phone numbers
configure control programs
set system alarm reporting parameters
energize relay
configure advanced statistics channel group
set AC & Standby sequencer parameters
configure status page
configure all settings
set time where hh = hours, mm = minutes, ss = seconds
set user timeout
set unit name and number
196
Advertisement
Table of Contents
