Vertiv NetSure LMS1000 User Manual page 386

SET NETSURE SYSTEM CURLIMIT
Description: Sets the VPS/NPS "current limit value".
Command Level: 6
Syntax: SET NETSURE SYSTEM CURLIMIT
SE N SY CURLIMIT
Comments: The current value is displayed, followed by a prompt to enter a new value.
Notes: The following message is displayed if the setting was not accepted by the MCA.
Power system did not accept the new value, setting remains unchanged.
Related Commands: none
Example:
Command<6>: SET N SYSTEM CURLIMIT
Current limit: 500 Amps
Current limit:
Vertiv™ | NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
386