RETRIEVE-USER-SECURITY
(RTRV-USER-SECU)
Referenced In: TR-TSY-000835, Issue 3, pg. 103
General Description: Retrieves a user's security parameters. The calling identifier (<cid>) parameter (i.e.,
LMS1000 user primary phone number), and user access privilege (<uap>) parameter (i.e., LMS1000 user access
level) of the specified user is retrieved.
Related Commands: None
LMS1000 Access Level: 6
An error response with the error code PICC is returned if this command is entered by a valid user whose level of
access is less than the access level of this command.
LMS1000 Equivalent: None
LMS1000 Input Format Variations:
<aid>
The access identifier (<aid>) parameter is the same value as the user identifier (<uid>) parameter for the user
whose security parameters are being retrieved. If the user being retrieved is not an active user, then an error
response is returned with the error code IIAC.
LMS1000 Response Format Variations:
<cid>
This is the calling identifier parameter of the user whose security parameters are being retrieved. The value is
derived from the PRIMARY PHONE attribute from the specified user's LMS1000 user configuration. It can
either be the network address or the phone number of the specified user. If the primary phone number
parameter does not meet the syntax requirements for the <cid> parameter, the error code PIFC is returned.
<uap>
This is the user access privilege parameter of the user whose security parameters are being retrieved. The
value is derived from the ACCESS LEVEL attribute from the specified user's LMS1000 user configuration.
<keyword-defined block>
This parameter has no relevance in LMS1000 and is not be returned.
Vertiv™
| NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
495