Table of Contents
Advertisement
NPS MCA Events: The following actions performed via LMS1000 or detected by LMS1000 (#26 below) are
recorded in the events log.
1.
System float voltage set
2.
System test/equalize voltage set
3.
System high voltage shutdown set
4.
System current limit set
5.
System output voltage calibration reading set
6.
NAG (audible alarm cutoff reset time period ) minutes set
7.
Battery charge temperature compensation module's calibration voltage set
8.
System high voltage alarm #1 set
9.
System high voltage alarm #2 set
10.
System 50% battery on discharge alarm set
11.
System battery on discharge alarm set
12.
System overcurrent alarm set
13.
System operating mode (float or test/equalize) changed
14.
Subsystem high voltage alarm set
15.
Subsystem low voltage alarm set
16.
PCU toggled on or off (TR feature)
17.
Number of available PCU mounting positions changed
18.
Subsystem overcurrent alarm set
19.
Subsystem output voltage calibration reading set
20.
LVD "disconnect" set
21.
LVD "reconnect" set
22.
Inventory reset
23.
MCA custom message set
24.
PCU custom message set
25.
MCA remote access password set
26.
LMS1000/MCA communications link broken
27.
Previously downloaded configuration uploaded to the NPS. Two events are recorded for this action.
"NETSURE system uploaded" and "NPS settings uploaded".
28.
Number of temperature probes changed
29.
PCU fan speed set
30.
PCU load share alarm set
31.
LVD manually reconnected
32.
Battery overcurrent set
33.
Auto equalize multiplier set
34.
Digital temperature compensation slope set
35.
Digital temperature compensation maximum voltage set
36.
Digital temperature compensation minimum voltage set
37.
Battery current limit set
38.
Temperature probe high alarm set
39.
Temperature probe low alarm set
40.
Digital temperature compensation source set
41.
Relay test time set
42.
Test/Equalize time set
Vertiv™
| NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
70
Advertisement
Table of Contents
