SET NETSURE SYSTEM RLYTESTTIME
Description: Sets the VPS/NPS "alarm relay test time period" value.
Command Level: 5
Syntax:
SET NETSURE SYSTEM RLYTESTTIME
SE N SY R
Comments: The current value is displayed, followed by a prompt to enter a new value.
Notes: The following message is displayed if the setting was not accepted by the MCA:
Power system did not accept the new value, setting remains unchanged.
Related Commands: none
Example:
Command<5>: SET NETSURE SYSTEM RLYTESTTIME
Relay Test Time: 45 seconds
Relay Test Time:
Vertiv™
| NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
396