Table of Contents
Advertisement
NODE LIST <n>
NODE REPLACE <n>
SET ACO
SET AID <n>
SET ANSWER <n>
SET CHANNELS
SET CLASS <n>
SET CMD <n>
SET COM
SET DATE <mm/dd/yy>
SET DEFAULTS
SET EFF
SET EMAIL
SET GATEWAY
SET INFO <n>
SET LED <n>
SET LIMITS <tn>
SET MAIL
SET MODE
SET PERIODS <tn>
SET PHONE
SET PROGRAM <tn>
SET REPORT
SET RLY <n>
SET STATS CHANNELS
SET SEQUENCE
SET STATUS <n>
SET SYSTEM
SET TIME <hh:mm:ss>
SET TIMEOUT <n>
SET UNIT
SET USERS <n>
SET VI
SET NETSURE
SNMP GET <comm name>
SNMP OFF
SNMP ON
SNMP SET <comm name>
TRAPS ADD <n>
TRAPS DELETE <n>
TRAPS OCCURRED
TRAPS OFF
TRAPS ON
TRAPS PERSISTENT
Vertiv™
| NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
view user and hardware configuration for nodes
replace a node
cutoff present alarms from affecting relays
configures access identifier
set number of rings before the system answers
set user defined channels
set programmable alarm classifications
set programmable commands
set local comm port configuration
set date where mm = month, dd = date, yy = year
set system default parameters
set Energy Management parameters
set IP DNS server, SMTP Server, and return mail addresses
set GATEWAY port communications data rate
configure information pages
turn LED on
set channel alarm limits
send mail to users
modify configuration of TL1 port settings
set time periods
set user phone numbers
configure control programs
set system alarm reporting parameters
energize relay
configure advanced statistics channel group
set AC & Standby sequencer parameters
configure status page
configure all settings
set time where hh = hours, mm = minutes, ss = seconds
set user timeout
set unit name and number
configure a user
set Plant Voltage and Load settings
configure VPS/NPS Power System settings
set the SNMP GET community name
disable SNMP access
enable SNMP access
set the SNMP SET community name
add a new SNMP Trap recipient to the list of TRAP hosts
remove a host address from the list of TRAP hosts
disable/enable the system's ability to send SNMP Occurred
Alarm TRAPS
disable the system's ability to send SNMP TRAPs
enable the system to send SNMP TRAPs
disable/Enable the system's ability to send SNMP Persistent
Alarm TRAPS or set the Persistent Alarms reporting
interval
192
Advertisement
Table of Contents
