Table of Contents
Advertisement
REPORT CONDITION
(REPT COND {EQPT/COM})
Referenced In: TR-NWT-000833, Issue 5, pg. 5-21
General Description: Provides a periodic report of selected LMS1000 standing conditions such as equipment
units out of service, etc. The reporting period and conditions are defined in the LMS1000's requirements.
Related Commands: RETRIEVE-CONDITION
Related Messages: REPORT EVENT
LMS1000 Equivalent: None
LMS1000 Message Format Variations:
<aid>
Identifies the single entity in the LMS1000 to which the condition pertains. If the message code modifier is
COM, then this parameter must be COM, indicating a system-wide condition that is not specific to a particular
sub-unit. A NULL value is not permitted with this parameter. Parameter grouping cannot be used with this
parameter.
<ntfcncde>
This is the notification code parameter associated with a single alarm condition given in this block.
Valid values are as follows:
CR
Critical alarm
MJ
Major alarm
MN
Minor alarm
NA
Not alarmed
NR
Not reported when the event occurs
A NULL value for the notification code defaults to NA.
Values are derived from the NOTIFICATION CODE attribute of the LMS1000 channel or limit configuration with
which the alarm condition is associated. Parameter grouping cannot be used with this parameter.
<condtype>
This is the condition type parameter of the alarm indication given in this block. Values are derived from the
CONDITION TYPE attribute of the LMS1000 channel or limit configuration with which the alarm condition is
associated. Parameter grouping cannot be used with this parameter.
<srveff>
This is the service effect parameter associated with a single alarm condition given in this block.
Valid values are as follows:
SA
Service-affecting condition immediate action required.
NSA
Nonservice-affecting condition, action required.
Vertiv™
| NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
509
Advertisement
Table of Contents
