Vertiv NetSure LMS1000 User Manual page 395

SET NETSURE SYSTEM OVRCURRENT
Description: Sets the VPS/NPS "system overcurrent alarm" value.
Command Level: 5
Syntax: SET NETSURE SYSTEM OVRCURRENT
SE N SY OVRCURRENT
Comments: The current value is displayed, followed by a prompt to enter a new value.
Notes: The following message is displayed if the setting was not accepted by the MCA.
Power system did not accept the new value, setting remains unchanged.
Related Commands: none
Example:
Command<5>: SET N SYSTEM OVRCURRENT
System Overcurrent: 2000 Amps
System Overcurrent:
Vertiv™ | NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
395