Table of Contents
Advertisement
SET NETSURE SYSTEM TEMPCOMP
Description: Sets the VPS/NPS battery charge temperature compensation module's "calibration voltage" value.
Command Level: 6
Syntax:
SET NETSURE SYSTEM TEMPCOMP
SE N SY TEMPCOMP
Comments: The current value is displayed, followed by a prompt to enter a new value.
Notes: The following message is displayed if the setting was not accepted by the MCA.
Invalid value entered, request to update setting denied.
Related Commands: none
Example:
Command<6>: SET N SYSTEM TEMPCOMP
Temperature compensation Voltage: 48.09 VDC
Temperature compensation Voltage:
Vertiv™
| NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
397
Advertisement
Table of Contents
