Vertiv NetSure LMS1000 User Manual page 477

RETRIEVE-ALARM-ENVIRONMENT
(RTRV-ALM-ENV)
Referenced In: TR-NWT-000833, Issue 5; pg. 4-217
General Description: Instructs LMS1000 to send the current state of its alarm conditions associated with the
LMS1000 environment.
Related Commands: None
Related Messages: REPORT ALARM ENVIRONMENT
LMS1000 Access Level: 1
LMS1000 Equivalent: None
LMS1000 Input Format Variations:
<aid>
The access identifier (<aid>) parameter identifies equipment associated with the environmental alarm being
requested. Entering a value of ALL requests retrieval of all environmental alarms specified by the notification
code (<ntfcncde>) parameter and alarm type (<almtype>) parameter. A NULL value is not permitted for this
parameter. Invalid values received for this parameter return an error response with the error code IIAC.
<ntfcncde>
Specifies the notification code parameter associated with the environmental alarm conditions being retrieved.
This parameter is an attribute of the LMS1000 channel or limit configuration.
Valid values for this parameter are as follows:
CR critical alarm
MJ major alarm
MN minor alarm
NULL request retrieval of environmental alarm conditions for all of the above codes
Invalid values for this parameter return an error response with the error code IDNV.
<almtype>
Specifies the alarm type parameter associated with the environmental alarms being retrieved. Specifying a
NULL value requests retrieval of all types of environmental alarms. Values are derived from the CONDITION
TYPE attribute of the LMS1000 channel or limit configuration with which the alarm is associated. A value of
MISC for this attribute is not supported in LMS1000. The error code for an invalid value for this parameter is
INUP.
<almmsg>
This parameter is not supported in LMS1000.
LMS1000 Response Format Variations:
<ntfcncde>
Vertiv™ | NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
477