Table of Contents
Advertisement
<ntfcncde>
This is the notification code parameter associated with a single condition given in this block. Values are derived
from the NOTIFICATION CODE attribute of the LMS1000 channel or limit configuration with which the alarm
condition is associated.
Valid values for this parameter are as follows:
CR
critical alarm
MJ
major alarm
MN
minor alarm
NA
not alarmed
NR
not reported
NULLdefaults to NA when the <typerep> parameter is a condition type, and has no meaning if the <typerep>
parameter is a state
<typereq>
This is the type of the condition being given in this block. Values are derived from the CONDITION TYPE
attribute of the LMS1000 channel or limit configuration with which the condition is associated. If no condition
exists on an LMS1000 channel, then the value of this parameter is IS-NR (in service-normal).
<srveff>
This is the service effect parameter associated with a single alarm condition given in this block. Valid values are
the same as for the input format. Values are derived from the SERVICE EFFECT CODE attribute of the
LMS1000 channel or limit configuration with which the alarm condition is associated. A NULL value implies
that the effect on service is unknown or that the <srveff> parameter does not apply.
<ocrdat>
This is the date when the triggering event occurred. The format for this parameter is MOY-DOM (Month-Of-
Year - Day-Of-Month). MOY ranges from 1 to 12, and DOM ranges from 1 to 31. A NULL value for this
parameter defaults to the current date unless the <ocrtm> parameter is NULL, then this parameter does not
apply.
<ocrtm>
This is the time when the triggering event occurred. The format for this parameter is HOD-MOH-SOM (Hour-
Of-Day - Minute-Of-Hour - Second-Of-Minute). HOD ranges from 0 to 23. MOH and SOM range from 0 to 59.
A NULL value means this parameter and the <ocrdat> parameter are not applicable.
<locn>, <dirn>
These parameters do not apply to LMS1000. A NULL value is inserted for them when the <tmper> parameter
has a value other than NULL.
<tmper>
This is the accumulation time period for Performance Monitoring (PM) parameters. It represents the length of
time the condition has been active. If the condition or state is normal, it defaults to NULL. The format for this
parameter is VAL-UN, where valid values for VAL (value) and UN (unit) are:
Vertiv™
| NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
484
Advertisement
Table of Contents
