Table of Contents
Advertisement
REPORT EVENT
(REPT EVT {EQPT/COM})
Referenced In: TR-NWT-000833, Issue 5, pg. 5-35
General Description: Generated by LMS1000 to report the occurrence of non-alarmed events. Trouble
events occurring in LMS1000 are classified as alarmed and non-alarmed events. This message may also be
used to report the recovery from off-normal or trouble conditions. This is done by using the value NORMAL for
the parameter CONDTYPE, and associating the previous trouble report by the fractional part of the automatic
tags (atag).
Related Commands: RETRIEVE-ALARM, RETRIEVE-CONDITION
Related Messages: REPORT ALARM
LMS1000 Equivalent: None
LMS1000 Message Format Variations:
<aid>
Identifies the single entity in LMS1000 to which the alarm pertains. If the message code modifier is COM, then
this parameter must be COM, indicating a system-wide failure that is not specific to a particular sub-unit. A
NULL value is not permitted with this parameter. Parameter grouping cannot be used with this parameter.
<condtype>
This is the condition type parameter of the event given in this block. Values are derived from the CONDITION
TYPE attribute of the LMS1000 channel or limit configuration with which the alarm condition is associated.
Parameter grouping cannot be used with this parameter.
<condeff>
Indicates the effect of the event on the condition of LMS1000. The event may initiate a standing condition (i.e.,
a non-alarmed condition occurrence), or may clear a standing condition or alarm. Parameter grouping cannot
be used with this parameter.
Valid values are as follows:
CL Standing condition cleared. This indicates that an existing alarmed or non-alarmed condition has
cleared.
SC Standing condition raised. This indicates that a non-alarmed condition has occurred.
TC Transient condition (this condition is not supported).
<ocrdat>
This is the date when the triggering event occurred (i.e., the threshold was crossed). The format for this
parameter is MOY-DOM (Month-Of-Year - Day-Of-Month). MOY ranges from 1 to 12, and DOM ranges from 1 to
31. A null value for this parameter defaults to the date in the message header.
<ocrtm>
Vertiv™
| NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
511
Advertisement
Table of Contents
