Vertiv NetSure LMS1000 User Manual page 197

SET USERS <n>
SET VI
SNMP GET <comm name>
SNMP OFF
SNMP ON
SNMP SET <comm name>
TRAPS ADD <n>
TRAPS DELETE <n>
TRAPS OCCURRED
TRAPS OFF
TRAPS ON
TRAPS PERSISTENT
TRAPS RETIRED
TRAPS VERSION <V1|V2>
PRCONFIG NPS
PRCONFIG NPS N<#>
PRCONFIG NPS N<#>-<#>
PRCONFIG NPS SETTINGS
PRCONFIG NPS INVENTORY
PRCONFIG NPS PCU
PRCONFIG NPS DISTRIBUTION
Programmed Command:
where: <> anything enclosed in brackets is optional
n is a valid number
t is a type A, B, F, G, L, R for Analog, Binary,
Function, Group, LED or Relay
Vertiv™ | NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
configure a user
set Plant Voltage and Load Channels
set the SNMP GET community name
disable SNMP access
enable SNMP access
set the SNMP SET community name
add a new SNMP Trap recipient to the list of TRAP hosts
remove a host address from the list of TRAP hosts
disable/enable the system's ability to send SNMP Occurred
Alarm TRAPS
disable the system's ability to send SNMP TRAP's
enable the system to send SNMP TRAP's
disable/Enable the system's ability to send SNMP Persistent
Alarm TRAPS or set the Persistent Alarms reporting interval
disable/enable the system's ability to send SNMP Retired
Alarm TRAPS
change the version of SNMP TRAP's sent by the system
Displays the NPS system adjustment settings
alarm setpoints values, and configuration
parameters and the NPS hardware equipment
inventory for all bays and the MCA node.
Displays only the NPS hardware equipment
inventory for the specified bay.
Displays only the NPS hardware equipment inventory
for valid NPS bays and the MCA node that fall
within the specified range of LMS node numbers.
Displays only the NPS system adjustment settings
alarm setpoints values, and configuration parameters.
Displays only the NPS hardware equipment
inventory for all bays and the MCA node.
Displays only the NPS hardware equipment
inventory of PCUs
Displays only the NPS hardware equipment
inventory of bay distribution panels.
Command Strings:
197