Table of Contents
Advertisement
SET NETSURE SYSTEM HIVLTALM1
Description: Sets the VPS/NPS "system high voltage alarm 1" value.
Command Level: 5
Syntax:
NETSURE SYSTEM HIVLTALM1
SE N SY HIVLTALM1
Comments: The current value is displayed, followed by a prompt to enter a new value.
Notes: The following message is displayed if the setting was not accepted by the MCA.
Power system did not accept the new value, setting remains unchanged.
Related Commands: none
Example:
Command<5>: SET N SYSTEM HIVLTALM1
System High Voltage 1 Alarm: 50.00 VDC
System High Voltage 1 Alarm:
Vertiv™
| NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
389
Advertisement
Table of Contents
