Vertiv NetSure LMS1000 User Manual page 237

01--06
07--08
09--24
Dist. Panel 2-02: Not Installed
PCU: -48 VDC Output
Pos. Cap. Description
---------------------------------------------------------------------------------
02-01 200A XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX 506401
02-02 200A XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX 506401
02-03 200A XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX 506401
02-04 --- open ---
02-05 --- open ---
02-06 --- open ---
02-07 --- open ---
02-08 --- open ---
02-09 --- open ---
02-10 --- open ---
CAN I/O Cards:
Pos. Description
------------------------------------------------------------------------------
02-01 XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX RCB SPEC# 514348
02-02 XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX RCB SPEC# 514348
02-03 XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX RCB SPEC# 514348
02-04 --- open ---
02-05 --- open ---
02-06 --- open ---
02-07 --- open ---
MCA:
Description
------------------------------------------------------------------------
this is the MCA
System voltage is Averaged
Temperature sensor reporting
Temperature is measured in degrees : Celsius
System distribution loads A and B are activated
Float mode is active
Power Share is inactive
Alternate Current Limit is active , limiting @ 90% of output capacity
___________________________________________________________________________________
Command<6>: PR NPS SET
Vertiv™ | NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
Plug In B
Fuse B
--- open ---
Spec. Number
509478
Plug In 02-01 Load
Fuse 02-07 Load
Spec. Number
Spec. Number Ser. #
67567872
67633409
67698946
Ser. #
2801621
Ser. # FW Ver.
34210048 2.0.2.0
34275585 2.0.2.0
34341122 2.0.2.0
FW Ver.
2.0.4.0
2.0.4.0
2.0.4.0
FW Ver.
1.0.0.14
237