Vertiv NetSure LMS1000 User Manual page 496

SET-ATTRIBUTE
(SET-ATTR-{EQPT})
Referenced In: TR-NWT-000833, Issue 5, pg. 4-385
General Description: Instructs LMS1000 to set the current notification code associated with the specified
events.
An entry is made in the LMS1000's event log indicating this command was executed by the current user.
Related Commands: RETRIEVE-ATTRIBUTE
LMS1000 Access Level: 6
An error response with the error code PICC is returned if this command is entered by a valid user whose level of
access is less than the access level of this command.
LMS1000 Equivalent: None
LMS1000 Input Format Variations: The command code modifier COM is not supported.
<aid>
Specifying a value of ALL for the access identifier (<aid>) parameter requests setting of attributes for all access
identifiers of the type defined by the command code modifier. A NULL value is not permitted for this
parameter. Invalid values received for this parameter return an error response with the error code IIAC.
<ntfcncde>
Specifies the notification code parameter associated with the alarm conditions being set. This parameter is an
attribute of the LMS1000 channel or limit configuration.
Valid values for this parameter are as follows:
CR critical alarm
MJ major alarm
MN minor alarm
NA not alarmed
NR not reported
NULL defaults to NA
Invalid values for this parameter return an error response with the error code IDNV.
<condtype>
The condition type (<condtype>) parameter identifies the type of event for which a notification code
(<ntfcncde>) parameter is being changed. This parameter is an attribute of the LMS1000 channel or limit
configuration. This parameter is required in the input. Invalid values for this parameter return an error
response with the error code IDNV.
<locn>
This parameter does not apply to LMS1000. The only valid value for this parameter is NULL. Invalid values for
this parameter return an error response with the error code IDNV.
<dirn>
Vertiv™ | NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
496