Table of Contents
Advertisement
string stored in the user PRIMARY PHONE NUMBER attribute prior to transmitting an autonomous message.
This assumes that an existing string in the user PRIMARY PHONE NUMBER attribute can be detected from a
user's configuration.
Auto-Logoff for Autonomous Messages: Currently, there is no auto-logoff of users who have established a
session via the TL1 port. Pending autonomous messages are sent after the current user session is ended.
Related Commands: MODE
Example:
TL1/X.25 Software Option Installed
Command<6>: SET MODE
TL1 Mode: Direct
TL1/X.25 Comm Port Setting: 9600, n, 8, 1
Session Timeout:
600 min
Auto logon: Enabled
Auto logon user: User #7
AID delimiter: Yes
Enter new TL1/X.25 port data rate:
Session Timeout (0-1440, 0 = disable):
Auto logon (Y or N):
Auto logon user:
AID Delimiter (Y or N):
Save changes (Y or N):
Must issue a hardware reset for changes to take effect
TL1 (over Ethernet) Software Option Installed
Command<6>: SET MODE
TL1 Mode: Telnet
TCP Keepalive: Enabled
Port: 2020
Session Timeout:
600 min
Auto logon: Enabled
Auto logon user: User #7
AID delimiter: Yes
Enter new TL1 port number:
TCP Keepalive (Y or N): Y
Session Timeout (0-1440, 0 = disable):
Auto logon (Y or N):
Auto logon user:
AID Delimiter (Y or N):
Save changes (Y or N):
Must issue a hardware reset for changes to take effect
Vertiv™
| NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
288
Advertisement
Table of Contents
