Vertiv NetSure LMS1000 User Manual page 168

F0001=A0001+A0002+A0003
___________________________________________________________________________________
Command<5>: CONFIG R0001
RELAY CHANNEL CONFIGURATION AS OF 07:35:40 ON 01/01/01.
Chan Description
R0001 Relay Channel 1
Sub-access ID
RELAY1
Condition Description
THIS IS RELAY CHANNEL R01'S CONDITION DESCRIPTION
CONTROL PROGRAM:
R0001=B0001
Channel active (Y or N): Y
Name: Relay Channel 1
Name:
Sub-access Identifier: RELAY1
Sub-access Identifier:
Alarm Type: Y
Alarm Type (Y or N):
System Alarm Report mode: Y
System Alarm Report mode (Y or N):
Alarm Class Number: 0
Condition Type: HIGH
Condition Type:
Condition Description:
THIS IS RELAY CHANNEL R01'S CONDITION DESCRIPTION
Condition Description:
Notification Code: CR
Notification Code:
Service Effect Code: SA
Service Effect Code:
Affected by ACO: N
Affected by ACO (Y or N): Y
Cycle Freq (min): 0
Cycle Freq (min):
Control Type:
Control Type:
Off Delay Time: 0s
Off Delay Tim:
On Delay Time: 0s
On Delay Time:
Save changes (Y or N): Y
Enter Program Line:
R01=B1|B2
___________________________________________________________________________________
Command<5>: CONFIG L0001
LED CHANNEL CONFIGURATION AS OF 07:35:00 ON 01/01/01.
Chan Description
L0001 LED Channel 1
Sub-access ID
Vertiv™ | NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
Act Alm Rpt Class Set ACO Cycle Off-Dly-On
Y Y Y
Ctrltype Condtype
HIGH
2
Act Alm Rpt Class Off-Dly-On
Y Y
Ctrltype Condtype
N N 0m 0s
Ntfc Svef
CR SA
Y 0s 0s
Ntfc Svef
0s
168