Table of Contents
Advertisement
SET-SYSTEM_IDENTIFICATION
(SET-SID)
Referenced In: TA-NWT-000199, Issue 6, Supplement 1, pg. 3-30
General Description: Instructs LMS1000 to change its system identifier (SID) parameter to a given value. The
system identifier parameter can also be set using the "SET UNIT" command.
LMS1000 uses the value of the system identifier parameter as the target identifier in an input command and
source identifier in a command response or autonomous message.
An entry is made in the LMS1000's event log indicating this command was executed by the current sessions
user.
Related Commands: None
LMS1000 Access Level: 6
An error response with the error code PICC is returned if this command is entered by a valid user whose level of
access is less than the access level of this command.
LMS1000 Equivalent: SET UNIT
LMS1000 Input Format Variations:
<aid>
The access identifier (<aid>) parameter does not apply. The only valid value for this parameter is NULL. Invalid
values received for this parameter return an error response with the error code IIAC.
<sid>
This parameter determines the new system identifier to be assigned to LMS1000. The value may be any valid
simple or compound TL1 identifier, or a text string with a maximum length of twenty characters. Valid character
values are any alphanumeric characters or the - character. Invalid values for this parameter return an error
response with the error code IDNV.
LMS1000 Response Format Variations: None
Vertiv™
| NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
500
Advertisement
Table of Contents
