Vertiv NetSure LMS1000 User Manual page 506

REPORT ALARM
(REPT ALM {EQPT/COM})
Referenced In: TR-NWT-000833, Issue 5, pg. 5-5
General Description: Generated by an LMS1000 to report the occurrence of alarmed events. Trouble events
occurring in LMS1000 are classified as alarmed or non-alarmed events.
Related Commands: RETRIEVE-ALARM, RETRIEVE-CONDITION
Related Messages: REPORT EVENT
LMS1000 Equivalent: None
LMS1000 Message Format Variations:
<aid>
Identifies the single entity in LMS1000 to which the alarm pertains. If the message code modifier is COM, then
this parameter must be COM, indicating a system-wide failure that is not specific to a particular sub-unit. A
NULL value is not permitted with this parameter. Parameter grouping cannot be used with this parameter.
<ntfcncde>
This is the notification code parameter associated with a single alarm condition given in this block.
Valid values are as follows:
CR Critical alarm
MJ Major alarm
MN Minor alarm
CL Cleared alarm
Values are derived from the NOTIFICATION CODE attribute of the LMS1000 channel or limit configuration with
which the alarm condition is associated. Parameter grouping cannot be used with this parameter.
<condtype>
This is the condition type parameter of the alarm indication being given in this block. Values are derived from
the CONDITION TYPE attribute of the LMS1000 channel or limit configuration with which the alarm condition is
associated. Parameter grouping cannot be used with this parameter.
<srveff>
This is the service effect parameter associated with a single alarm condition given in this block.
Valid values are as follows:
SA Service-affecting condition immediate action required.
NSA Nonservice-affecting condition, action required.
Values are derived from the SERVICE EFFECT CODE attribute of the LMS1000 channel or limit configuration
with which the alarm condition is associated. Parameter grouping cannot be used with this parameter.
<ocrdat>
Vertiv™ | NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
506