Set Netsure System 50%Batondisch - Vertiv NetSure LMS1000 User Manual

SET NETSURE SYSTEM 50%BATONDISCH

Description: Sets the VPS/NPS "system 50% battery on discharge alarm" value.
Command Level: 5
Syntax: SET NETSURE SYSTEM 50%BATONDISCH
SE N SY 50%
Comments: The current value is displayed, followed by a prompt to enter a new value.
Notes: The following message is displayed if the setting was not accepted by the MCA.
Power system did not accept the new value, setting remains unchanged.
Related Commands: none
Example:
Command<5>: SET N SYSTEM 50%BATONDISCH
System 50% Battery On Discharge:
System 50% Battery On Discharge:
Vertiv™ | NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
376