Table of Contents
Advertisement
Adding an Input/Output (I/0) Circuit Card
Refer to the Installation Instructions (Section 5879) located in the separate INSTALLATION MANUAL for
procedures to do the following. Section 5879 is also provided on the CD (Electronic Documentation Package)
furnished with your system.
• Install the circuit card.
• Wire to the circuit card.
• Configure the associated channels of the circuit card.
NOTE!
When adding or removing a circuit card from the network, the associated Node must be re-
initialized before the network recognizes the addition or removal of the circuit card. If the Node is not
re-initialized, alarms may be present. Re-initialize the Node to clear the alarms. Note that the
configuration for the channels on the source node may need re-configuring after executing the NODE
INITIO command. Refer to the "NODE INITIO" command in the Commands section.
Adding a Modem Circuit Card
Refer to the Installation Instructions (Section 5879) located in the separate INSTALLATION MANUAL for
procedures to do the following. Section 5879 is also provided on the CD (Electronic Documentation Package)
furnished with your system.
• Install the circuit card.
• Connect the phone line.
• Configure modem parameters.
Upgrading the Firmware
Contact a Vertiv Co. service facility. Contact information is provided in a Service Information Sheet (Section
4154). Section 4154 can be accessed via the CD (Electronic Documentation Package) furnished with your
system.
Adding Software Options
Contact a Vertiv Co. service facility. Contact information is provided in a Service Information Sheet (Section
4154). Section 4154 can be accessed via the CD (Electronic Documentation Package) furnished with your
system.
TROUBLESHOOTING AND REPAIRING LMS1000
Contact Information
Refer to Section 4154 (Service Information Sheet) for service contact information. You can find Section 4154 on
the CD (Electronic Documentation Package) furnished with your system.
Vertiv™
| NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
519
Advertisement
Table of Contents
