Set Netsure Subsystem Lvalm - Vertiv NetSure LMS1000 User Manual

SET NETSURE SUBSYSTEM LVALM

Description: Sets the VPS/NPS "subsystem low voltage alarm" value.
Command Level: 5
Syntax: SET NETSURE SUBSYSTEM LVALM
SE N SU LVALM
Comments: The current value is displayed, followed by a prompt to enter a new value.
Notes: The following message is displayed if the setting was not accepted by the MCA.
Power system did not accept the new value, setting remains unchanged.
The following message is displayed if a subsystem is not installed.
No Subsystem Installed
Related Commands: none
Example:
Command<5>: SET N SUBSYSTEM LVALM
Subsystem Low Voltage Alarm: 27.00 VDC
Subsystem Low Voltage Alarm:
Vertiv™ | NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
370