Table of Contents
Advertisement
ENTER-USER-SECURITY
(ENT-USER-SECU)
Referenced In: TR-NWT-000835, Issue 3, pg. 3-71
General Description: Activates a user and enters the specified security parameters for this user. These
security parameters consist of the user identifier (<uid>) parameter (i.e., LMS1000 user name), privilege
identifier (<pid>) parameter (i.e., LMS1000 user password), calling identifier (<cid>) parameter (i.e., LMS1000
user primary phone number), and user access privilege (<uap>) parameter (i.e., LMS1000 user access level).
When executed, the command sets the USER ACTIVE attribute of this user's LMS1000 user configuration to Y.
The command also sets the USER NAME, PASSWORD, PRIMARY PHONE, and ACCESS LEVEL attributes of
this user's LMS1000 user configuration to the specified values. The following attributes of this user's LMS1000
user configuration are also set as indicated.
Callback
N
Alternate Phone
(none entered)
Report Device
X25
Report Mode
TL1
If the specified access identifier (<aid>) parameter matches the NAME attribute of an inactive LMS1000 user,
the following attributes for this LMS1000 user remain unchanged. If the specified access identifier does not
match the NAME attribute of an inactive LMS1000 user, the following attributes of this user's LMS1000 user
configuration are set to the default values indicated below.
From Day
Thru Day
From Hour
Thru Hour
TL1 Report Condition Interval 0
Report Retry Time
An entry is made in the LMS1000's event log indicating this command was executed by the current sessions
user. The event description indicates that the specified user was activated.
Related Commands: None
LMS1000 Access Level: 6
An error response with the error code PICC is returned if this command is entered by a valid user whose level of
access is less than the access level of this command.
LMS1000 Equivalent: None
LMS1000 Input Format Variations:
<aid>
The access identifier (<aid>) parameter is the same value as the user identifier (<uid>) parameter for the user
who is being activated. The user identifier parameter is the new NAME attribute for this user's LMS1000 user
configuration. If the access identifier parameter matches the NAME attribute of an inactive LMS1000 user, that
user is activated. If the access identifier parameter does not match the NAME attribute of an inactive LMS1000
user, the first inactive LMS1000 user is activated. The NAME attribute for this user is changed to that specified
by this value. If there are no inactive LMS1000 users remaining, then an error response is returned with the
Vertiv™
| NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
1
7
0
23
15
463
Advertisement
Table of Contents
