Table of Contents
Advertisement
INHIBIT-MESSAGE-ALL
(INH-MSG-ALL)
Referenced In: TR-NWT-000833, Issue 5, pg. 4-117
General Description: Disables LMS1000 transmission of automatic messages.
Selective disabling of messaging is not implemented in LMS1000. Unreported alarms and events that occur
while autonomous messaging is inhibited are reported via the proper message type (REPORT ALARM or
REPORT EVENT) when autonomous messaging is re-enabled.
This command disables autonomous messaging for all LMS1000 user's whose REPORT DEVICE attribute is
X25. When executed, the command sets the REPORT MODE attribute of these users' LMS1000 user
configuration to OFF.
An entry is made in the LMS1000's event log indicating this command was executed by the current sessions
user. The event description indicates that automatic messaging was disabled.
Related Commands: None
LMS1000 Access Level: 6
An error response with the error code PICC is returned if this command is entered by a valid user whose level of
access is less than the access level of this command.
LMS1000 Equivalent: None
LMS1000 Input Format Variances: Command code modifiers other than ALL are not supported by LMS1000.
<aid>
The access identifier (<aid>) parameter can only be the value ALL. Invalid values received for this parameter
return an error response with the error code IIAC.
<ntfcncde>, <condtype>, <tmper>
These parameters are not implemented in LMS1000. The only valid value for these parameters are NULL.
Invalid values received for these parameters return an error response with the error code INUP.
LMS1000 Response Format Variances: None
Vertiv™
| NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
465
Advertisement
Table of Contents
