Table of Contents
Advertisement
85.
Daily/weekly statistics channel group set.
VPS/NPS MCA Events: The following actions performed at the VPS/NPS MCA local interface pad or event
(#28 below) are recorded in the events log.
1.
System float voltage set
2.
System test/equalize voltage set
3.
System high voltage shutdown set
4.
System current limit set
5.
System output voltage calibration reading set
6.
NAG (audible alarm cutoff reset time period) minutes set
7.
Battery charge temperature compensation module's calibration voltage set
8.
System high voltage alarm #1 set
9.
System high voltage alarm #2 set
10.
System 50% battery on discharge alarm set
11.
System battery on discharge alarm set
12.
System overcurrent alarm set
13.
System operating mode (float or test/equalize) changed
14.
Subsystem high voltage alarm set
15.
Subsystem low voltage alarm set
16.
PCU toggled on or off (TR feature)
17.
Number of available PCU mounting positions changed
18.
Number of PCUs installed changed
19.
Number/type of loads installed changed
20.
Number of LVD cards installed changed
21.
Subsystem overcurrent alarm set
22.
Subsystem output voltage calibration reading set
23.
LVD "disconnect" set
24.
LVD "reconnect" set
25.
ACO activated
26.
Subsystem Installed
27.
Subsystem Removed
28.
MCA Powered Down
29.
Number of temperature probes changed
30.
PCU fan speed set
31.
PCU load share alarm set
32.
LVD manually reconnected
33.
Battery overcurrent set
34.
Auto equalize multiplier set
35.
Digital temperature compensation slope set
36.
Digital temperature compensation maximum voltage set
37.
Digital temperature compensation minimum voltage set
38.
Battery current limit set
39.
Temperature probe high alarm set
40.
Temperature probe low alarm set
41.
Digital temperature compensation source set
42.
Relay test time set
43.
Test/Equalize time set
44.
VPS/NPS interface enabled
45.
VPS/NPS interface disabled
Vertiv™
| NetSure™ LMS Data Processing Unit User Manual (Section 5847) | Rev. ZA
69
Advertisement
Table of Contents
