Connect Cables To Fibre Channel Ports - HP StorageWorks Edge Switch 2/12 Installation Manual

Installing and Configuring the Edge Switch 2/12
2. Enter the feature key and click Activate. The interface displays a
3. Click Activate to activate the new feature key. The switch performs an IPL
Note:
Note:
only. Record the key to re-install the feature if required.
If the switch fails and must be replaced, obtain new feature keys from the HP
Authorization Center. Please have the serial numbers of the failed and replacement
switches.
4. Go to

Connect Cables to Fibre Channel Ports

Perform this task to connect devices to the switch:
1. Set the switch offline as follows:
2. Route single-mode or multi-mode fiber-optic cables (depending on the type of
3. Connect device cables to small form factor pluggable (SFP) transceivers.
4. Set the switch online as follows:
66
confirmation page with a warning, stating that this action overrides the current
set of switch features.
when the key is activated.
When Activate is selected, all current features are replaced with new features.
Feature keys are encoded to work with the serial number of the installed switch
"Configure Switch Network
a. Choose Operations >Online State to display the Online State tab.
b. Click Set Offline. The message "Your changes have been
successfully activated" displays.
SFP pluggable optic transceivers installed) from customer-specified devices
to ports at the front of the switch.
a. Choose Operations >Online State. The Operations page displays with
the Online State tab selected.
b. Click Set Online. The message "Your changes have been
successfully activated" displays.
Information" on page 40.
Edge Switch 2/12 Installation Guide