Sirona ORTHOPHOS SL 2D Installation Manual page 50

5 Installation: X-ray unit
5.3 Wall mounting (standard and option 1)
50
3. Set up the unit by tilting the transport pallet upward.
Tip: If you have transported the unit on the wooden support without a
pallet, set the unit upright with the wooden support. You can also use
the lateral styrofoam packaging as a support with this variation.
4. Loosen the nuts with washers (D) on both sides of the pallet (or
wooden support).
5. Take off the pallet (or wooden support).
6. Remove the threaded bolts (E).
Tip: Remove the lower bolts first, then the upper bolts.
The nuts (F) on the unit may remain inside the unit when the threaded
rods are removed. Remove the upper nuts. The lower nuts may
remain in the unit.
Sirona Dental Systems GmbH
Installation Manual ORTHOPHOS SL
64 95 142 D3632
D3632.031.01.02.02 03.2016