9S018: Test Step 10 - Sirona ORTHOPHOS SL 2D Installation Manual

Sirona Dental Systems GmbH
Installation Manual ORTHOPHOS SL
64 95 142 D3632
D3632.031.01.02.02 03.2016
S018: Test step 10
11.12.4.9
Setting the PWM values for the height adjustment creep speed
In user mode, check whether a correction is required for the speed for
upward and downward movement (creep speed). Here the bite block
must be deflected in such a way that the creep speed is effective in the
relevant direction (observe green arrows). The PWM index values are set
correctly if:
● the drive runs at approximately the same speed in both directions
● the drive spontaneously starts without jolting and concurrent to key
actuation
● the travel speed does not exceed 5 mm/s.
Symbol on the control
panel
Patient symbol key 1 (G) visible
Selection field
1
2
* factory settings
11 Commissioning, demo mode and repacking
11.12 Service routines for commissioning and repacking
Status Meaning
Occlusal bite block
connected
not visible Occlusal bite block not
connected
Parameters Range of values
U (upward travel) 1U – 15U* – 35U
D (downward travel) 1D – 20D* – 35D
159