Editing Coverage Areas; Specifying Mobility Domain, Radio Profile, And Wiring Closet Associations - 3Com WX4400 Reference Manual

132 C 5: P
HAPTER LANNING THE
Editing Coverage
Areas
3C M S
OM OBILITY YSTEM
Specifying Mobility Domain, Radio Profile, and Wiring Closet
Associations
To specify association information for the coverage area:
1 In the Mobility Domain list, select the Mobility Domain that contains the
MAPs used for this coverage area.
2 In the Radio Profile list, select the radio profile used for this coverage
area.
The profiles available depend on the Mobility Domain you selected in
step 1. For a policy to appear in this list, you must have already
configured a policy and selected the Wireless Service Profiles and Radio
Profiles checkbox in the Policy Areas dialog.
The policy you select applies to all radios associated with the coverage
area. If you type the name of a radio profile that does not already exist,
3WXM creates it.
3 In the Wiring Closet list, select the wiring closet that contains the WX
switch or switches to be connected to the shared MAP access points.
If the MAPs will be directly connected to WX switches, a wiring closet is
required. A wiring closet is not required if all of the MAPs in the coverage
area will be indirectly connected to WX switches through the network.
4 In the Redundant Wiring Closet list, select the wiring closet that will
provide redundant connection to the MAP access points. This is required
for directly connected MAPs, if you require the MAPs to have redundant
connections. Otherwise, this is not required.
Only AP models that have two Ethernet ports can support redundant
direct connections. However, models with one Ethernet port can support
redundant distributed connections.
5 Click Finish to complete the wizard and create the coverage area.
To edit existing coverage areas:
1 Display the floor plan in the Content panel.
2 In the Task List panel, click Floor.
3 Under Edit Floor, click Coverage Areas. The Coverage Areas List dialog is
displayed.