Stimulus Block; Floppy Disk Drive - Agilent Technologies ENA Series User Manual

Overview of Functions
Front Panel: Names and Functions of Parts

5. STIMULUS Block

A group of keys for defining the stimulus values (signal sources and triggers).

6. Floppy Disk Drive

A device for storing to and reading from a floppy disk the setup state of the
E5070/E5071A, measurement data, calibration data, data on images displayed on the LCD
screen, VBA (Visual Basic for Applications) programs, etc. The floppy disk drive is
compatible with a 3.5-inch, 1.44 MB, DOS (Disk Operating System) formatted floppy
disk.
A floppy disk access lamp is provided at the lower left of the floppy disk drive opening.
When the floppy disk drive is accessing a disk (for reading or writing), this lamp will light
up green.
A disk eject button is provided at the lower right of the floppy disk drive opening. Pressing
this button causes the inserted floppy disk to be ejected.
NOTE Insert a floppy disk into the floppy disk drive opening right side up in the direction of the
arrow marked on the disk.
Do not press the disk eject button while the floppy disk access lamp is on. Trying to
forcefully pull the floppy disk out while the lamp is on may damage the floppy disk or disk
drive.
28
Displays the data entry bar for specifying the sweep start
Key
frequency in the upper part of the screen. (It also displays
the Stimulus softkey menu for specifying the sweep range
on the right side of the screen.)
Displays the data entry bar for specifying the sweep stop
Key
frequency in the upper part of the screen. (It also displays
the Stimulus menu in the same way as
Displays the data entry bar for specifying the sweep center
Key
frequency in the upper part of the screen. (It also displays
the Stimulus menu in the same way as
Displays the data entry bar for specifying the frequency
Key
span in the upper part of the screen. (It also displays the
Stimulus menu in the same way as
Displays the Sweep Setup softkey menu on the right side of
Key
the screen. Manipulating the Sweep Setup menu enables
you to specify the signal source power level, sweep time,
number of points, sweep type, etc.
Displays the Trigger Setup softkey menu on the right side
Key
of the screen. Manipulating the Trigger menu enables you
to specify the trigger mode and trigger source. Specify the
trigger mode for each channel.
.)
.)
.)
Chapter 2