CHAPTER 8 SNMP-Based Management
2.
Configure SNMP community strings for access privileges:
●
Under the Read Only Community Strings group, configure read-only community strings
(see the table below).
●
Under the Read/Write Community Strings group, configure read-write community
strings (see the table below).
3.
Configure a community string for SNMP traps: Under the Misc. Settings group, in the 'Trap
Community String' field, configure a community string (see the table below).
4.
Click Apply, and then reset the device with a save-to-flash for your settings to take effect.
To delete a community string, delete the configured string, click Apply., and then reset the device
with a save-to-flash for your settings to take effect.
Table 8-1: SNMP Community String Parameter Descriptions
Read-Only Community Strings
configure system > snmp settings >
ro-community-string
[SNMPReadOnlyCommunityStringsPassword_
x]
Parameter
- 63 -
Mediant 4000 SBC | User's Manual
Description
Defines read-only SNMP community
strings. Up to five read-only community
strings can be configured.
The valid value is a string of up to 30
characters that can include only the
following:
■
Upper- and lower-case letters (a to z,
and A to Z)
■
Numbers (0 to 9)
■
Hyphen (-)
■
Underline (_)
For example, "Public-comm_string1".