Displaying Login Information Upon Login - AudioCodes Mediant 4000 SBC User Manual

CHAPTER 6 Web-Based Management
3. Configure the rule according to the parameters described in the table below.
4. Click Apply, and then save your settings to flash memory.
Table 6-9: Customize Access Level Table Parameter Descriptions
'Index'
[WebPagesAccessLevel_Index]
'Page Name'
[WebPagesAccessLevel_
PageNameFromTree]
'Read-Write Access Level'
[WebPagesAccessLevel_
RWAccessLevel]
'Read-Only Access Level'
[WebPagesAccessLevel_
ROAccessLevel]

Displaying Login Information upon Login

You can enable the device to display login information immediately upon Web login.
➢
To enable display of user login information upon login:
1. Open the Web Settings page (Setup menu > Administration tab > Web & CLI folder > Web
Settings).
2. Under the Security group, from the 'Display Last Login Information' drop-down list, select
Enable.
3. Click Apply.
Parameter Description
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines the Web page whose access level you want to
customize.
Defines the minimum user level to which you want to
assign read-write access privileges for the selected Web
page.
■ [50] Monitor
■ [100] Administrator (default)
■ [200] Security Administrator
Defines the minimum user level to which you want to
assign read-only access privileges for the selected Web
page.
■ [50] Monitor (default)
■ [100] Administrator
■ [200] Security Administrator
Note: The user level must be the same or lower than the
user level you configured in the 'Read-Write Access
Level' parameter. For example, you cannot assign read-
only privileges to the Security Administrator if you have
assigned read-write privileges to the Administrator.
- 49 -
Mediant 4000 SBC | User's Manual