Saving Configuration - AudioCodes Mediant 4000 SBC User Manual

CHAPTER 34 Basic Maintenance
➢
To unlock the device:
■ Click the UNLOCK button; the device unlocks immediately and accepts new incoming calls.
The 'Gateway Operational State' read-only field displays "UNLOCKED".

Saving Configuration

When you configure parameters and tables in the Web interface and then click the Apply button on
the pages in which the configurations are done, changes are saved to the device's volatile memory
(RAM). These changes revert to their previous settings if the device subsequently resets (hardware
or software) or powers down. Therefore, to ensure that your configuration changes are retained, you
must save them to the device's non-volatile memory (i.e., flash memory).
To save your settings to flash, click the Save button located on the toolbar. To remind you to save
your settings to flash, the Save button is displayed with a red border, as shown below:
To save configuration to flash through CLI, use the following command:
# write
Saving configuration to flash may disrupt current traffic on the device. To avoid this,
disable all new traffic before saving, by performing a graceful lock (see
Unlocking the Device).
- 656 -
Mediant 4000 SBC | User's Manual
Locking and