AudioCodes Mediant 4000 SBC User Manual page 392

CHAPTER 18 Core Entities
'Tags'
tags
[IPGroup_Tags]
'Call Setup Rules Set ID'
call-setup-rules-set-id
[IPGroup_CallSetupRulesSetId]
Quality of Experience
'QoE Profile'
qoe-profile
Parameter Description
Note: For IP-to-IP Routing rules that are configured for
destination based on tags (i.e., 'Destination Type'
parameter configured to Destination Tag), the parameter
is applicable only to the source IP Group and the device
searches the Dial Plan for a dial plan rule that matches
the prefix of the destination number only. For more
information on routing based on destination tags, see
Using Dial Plan Tags for Routing
Defines a tag, which can be implemented in one of the
following manners:
■ Classification based on source tags: If the tag
(name=value or value only) is the same tag as that of
the incoming SIP dialog (obtained from the Call
Setup Rule associated with the SIP Interface on
which the dialog is received) and configured in the
Classification table, then the incoming dialog is
classified to this IP Group. For more information, see
Configuring Classification Based on Tags
page 544.
■ Routing based on destination tags: Assigns a
Dial Plan tag which determines whether the
incoming SIP dialog is sent to this IP Group. The
parameter is used when IP-to-IP Routing rules are
configured for destinations-based on tags (i.e.,
'Destination Type' parameter configured to
Destination Tag). For more information, see
Dial Plan Tags for Routing
The valid value is a string of up to 70 characters. You
can configure the parameter with up to five tags, where
each tag is separated by a semicolon (;). Each tag can
have a name and value (e.g., Country=Ireland) or only a
value (e.g., Ireland). You can also configure multiple
tags with the same name (e.g.,
Country=Ireland;Country=Scotland).
Note: For tag-based classification, if multiple IP Groups
are configured with the same tag, the device classifies
the incoming SIP dialog to the first matching IP Group.
Assigns a Call Setup Rule Set ID to the IP Group. The
device runs the Call Setup rule immediately before the
routing stage (i.e., only after the classification and
manipulation stages).
By default, no value is assigned.
To configure Call Setup Rules, see
Setup Rules.
Assigns a Quality of Experience Profile rule.
By default, no value is defined.
- 359 -
Mediant 4000 SBC | User's Manual
Destinations.
on
Using
Destinations.
Configuring Call