Tls Parameters - AudioCodes Mediant 4000 SBC User Manual

CHAPTER 60 Configuration Parameters Reference
'SRTP Tunneling Authentication for RTCP'
configure voip > media security >
srtp-tnl-vld-rtcp-auth
[SRTPTunnelingValidateRTCPRxAuthentication]
configure voip > sip-definition
settings > srtp-state-behavior-mode
[ResetSRTPStateUponRekey]

TLS Parameters

The Transport Layer Security (TLS) parameters are described in the table below.
'TLS Client Re-Handshake Interval'
configure network >
security-settings > tls-re-
hndshk-int
[TLSReHandshakeInterval]
Parameter
Table 60-24:TLS Parameters
Parameter
■ The parameter is applicable only to
SRTP-to-SRTP calls and when both
endpoints use the same
authentication keys.
Enables validation of RTP tunneling
authentication for RTCP.
■ [0] Disable = (Default) The device
does not perform any validation and
forwards the packets as is.
■ [1] Enable = The device validates the
packets (e.g., sequence number) and
if successful, forwards the packets. If
validation fails, it drops the packets.
Note:
■ The parameter is applicable only to
SRTP-to-SRTP calls and when both
endpoints use the same
authentication keys.
Global parameter that enables
synchronization of the SRTP state
between the device and a server when a
new SRTP key is generated upon a SIP
session expire. You can also configure
this feature per specific calls, using IP
Profiles (IpProfile_
ResetSRTPStateUponRekey). For a
detailed description of the parameter and
for configuring this feature in the IP
Profiles table, see
Note: If this feature is configured for a
specific IP Profile, the settings of this
global parameter is ignored for calls
associated with the IP Profile.
Description
Defines the time interval (in minutes) between TLS
Re-Handshakes initiated by the device.
The interval range is 0 to 1,500 minutes. The default
is 0 (i.e., no TLS Re-Handshake).
- 909 -
Mediant 4000 SBC | User's Manual
Description
Configuring IP Profiles.