AudioCodes Mediant 4000 SBC User Manual page 334

CHAPTER 17 Quality of Experience
3. Click Apply, and then reset the device with a save-to-flash for your settings to take effect.
Table 17-1: Quality of Experience Settings Parameter Descriptions
Parameter
General
'Index'
tls
[QOESettings_Index]
'Primary OVOC Address'
server-name
[QOESettings_ServerName]
'Secondary OVOC Address'
secondary-server-name
[QOESettings_
SecondaryServerName]
'QoE Network Interface'
interface
[QOESettings_Interface]
'Keep Alive Time Interval'
keep-alive-time
[QOESettings_KeepAliveTime]
TLS
'Use TLS'
tls
[QOESettings_EnableTls]
Description
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines the address of the primary OVOC server to where
the QoE reports are sent.
The valid value is an IP address in dotted-decimal notation
or an FQDN (hostname).
Note: If you only configure a primary address (this
parameter) without a secondary address (see 'Secondary
OVOC Address' parameter below) and the address is an
FQDN, the device accepts up to two DNS-resolved IP
addresses. The first IP address is used for the primary
server and the second IP address for the secondary server.
If you configure both this parameter and the 'Secondary
OVOC Address' parameter with FQDNs, the device uses
only the first DNS-resolved IP address from each FQDN.
Defines the address of the secondary OVOC server to
where the QoE reports are sent. This is applicable only
when OVOC is in Geographical Redundancy HA mode.
The valid value is an IP address in dotted-decimal notation
or an FQDN (hostname).
Note: See the note for the 'Primary OVOC Address'
parameter (above).
Assigns an IP network interface from which the device
sends the QoE reports.
The default is the OAMP interface (O+M+C).
To configure network interfaces, see
Network Interfaces.
Defines the interval (in seconds) between every
consecutive keep-alive message that the device sends to
the OVOC server. Keep-alive messages can be useful to
keep the communication link between the deviceand
OVOC open when there is no other traffic flow between
them.
The default is 1. A value of 0 disables the keep-alive
feature.
Enables a TLS connection with the OVOC server.
■ [0] Disable (default)
■ [1] Enable
- 301 -
Mediant 4000 SBC | User's Manual
Configuring IP