AudioCodes Mediant 4000 SBC User Manual page 242

CHAPTER 16 Services
servers 1
ip-address 10.4.4.202
auth-port 1812
auth-ha-state "STANDBY"
acc-port 1813
acc-ha-state "STANDBY"
Where auth-ha-state and acc-ha-state display the authentication and accounting redundancy status
respectively. "ACTIVE" means that the server was used for the last sent authentication or
accounting request; "STANDBY" means that the server was not used in the last sent request.
●
●
The following procedure describes how to configure a RADIUS server through the Web interface.
You can also configure it through ini file [RadiusServers] or CLI (configure system > radius
servers).
➢
To configure a RADIUS server:
1. Open the RADIUS Servers table (Setup menu > IP Network tab > RADIUS & LDAP folder >
RADIUS Servers).
2. Click New; the following dialog box appears:
3. Configure a RADIUS server according to the parameters described in the table below.
4. Click Apply.
Table 16-7: RADIUS Servers Table Parameter Descriptions
Parameter
'Index'
[RadiusServers_
Index]
To enable and configure RADIUS-based accounting, see
Accounting.
The device can send up to 201 concurrent RADIUS requests per RADIUS service
type (Accounting or Authentication), per RADIUS server (up to three servers per
service type), and per local port (up to 2 local ports). For example, 402 (201 * 2)
concurrent RADIUS requests can be sent for Authentication and 402 (201 * 2) for
Accounting.
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Description
- 209 -
Mediant 4000 SBC | User's Manual
Configuring RADIUS