Dhcp Parameters - AudioCodes Mediant 4000 SBC User Manual

CHAPTER 60 Configuration Parameters Reference
'Default Secondary DNS Server IP'
configure network > dns settings > dns-
default-secondary-server-ip
[DefaultSecondaryDnsServerIp]

DHCP Parameters

The Dynamic Host Control Protocol (DHCP) parameters are described in the table below.
Parameter
'Enable DHCP'
[DHCPEnable]
[DhcpOption160Support]
[DHCP120OptionMode]
[DHCPSpeedFactor]
Parameter
Table 60-14:DHCP Parameters
Enables DHCP client functionality.
■ [0] Disable (default)
■ [1] Enable
Note:
■ For the parameter to take effect, a device reset is required.
■ For a detailed description of DHCP, see
Provisioning.
■ The parameter is a "hidden" parameter. Once defined and
saved to flash memory, its value doesn't revert to default even
if the parameter doesn't appear in the ini file.
Enables the use of DHCP Option 160.
■ [0] = (Default) Disable
■ [1] = Enable
For more information, see
Option 160 on page 695.
Note: For the parameter to take effect, a device reset is required.
Enables the acceptance of DHCP Option 120 in DHCP responses
sent by a DHCP server.
■ [0] = DHCP Option 120 is not supported and ignored if
received in the DHCP response.
■ [1] = (Default) DHCP Option 120 is supported and if received,
the device adds the SIP server information to the Proxy Set.
Defines the device's DHCP renewal speed for a leased IP
address from a DHCP server.
- 888 -
Mediant 4000 SBC | User's Manual
Description
For more information, see
Configuring Default DNS
Servers on page 119.
Defines the address of the
default secondary DNS
server.
The valid value is an IP
address in dotted-decimal
notation. The default is
8.8.4.4.
For more information, see
Configuring Default DNS
Servers on page 119.
Description
DHCP-based
Provisioning the Device using DHCP