Debugging And Diagnostics Parameters; General Parameters; Sip Test Call Parameters - AudioCodes Mediant 4000 SBC User Manual

CHAPTER 60 Configuration Parameters Reference
Parameter
'Offset'
configure system >
clock > summer-time >
offset
[DayLightSavingTimeOffset]

Debugging and Diagnostics Parameters

This subsection describes the device's debugging and diagnostic parameters.

General Parameters

The general debugging and diagnostic parameters are described in the table below.
Table 60-16:General Debugging and Diagnostic Parameters
Parameter
[EnableDiagnostics]
'Delay After Reset [sec]'
configure voip > sip-
definition advanced-
settings > delay-after-
reset
[GWAppDelayTime]
[EnableAutoRAITransmitBER]

SIP Test Call Parameters

The SIP Signaling Test Call parameters are described in the table below.
Description
Defines the DST offset (in minutes).
The valid range is 0 to 120. The default is 60.
Note: The offset setting is applied only on the hour. For
example, if you configure the parameter at 15:42, the device
applies the setting only at 16:00.
Determines the method for verifying correct functioning of
the different hardware components on the device. On
completion of the check and if the test fails, the device
sends information on the test results of each hardware
component to the Syslog server.
■ [0] = (Default) Rapid and Enhanced self-test mode.
■ [1] = Detailed self-test mode (full test of DSPs, PCM,
Switch, LAN, PHY and Flash).
■ [2] = A quicker version of the Detailed self-test mode
(full test of DSPs, PCM, Switch, LAN, PHY, but partial
test of Flash).
Note: For the parameter to take effect, a device reset is
required.
Defines the time interval (in seconds) that the device's
operation is delayed after a reset.
The valid range is 0 to 45. The default is 7 seconds.
Note: This feature helps overcome connection problems
caused by some LAN routers or IP configuration
parameters' modifications by a DHCP server.
Enables the device to send a remote alarm indication (RAI)
when the bit error rate (BER) is greater than 0.001.
■ [0] = Disable (default)
■ [1] = Enable
- 891 -
Mediant 4000 SBC | User's Manual
Description