Configuring Syslog Message Severity Level - AudioCodes Mediant 4000 SBC User Manual

CHAPTER 52 Syslog and Debug Recording
➢
To configure the Syslog server address:
1. Open the Logging Settings page (Troubleshoot menu > Troubleshoot tab > Logging folder >
Logging Settings).
2. In the 'Syslog Server IP' field [SyslogServerIP], enter the IP address of the Syslog server.
3. In the 'Syslog Server Port' field, enter the port of the Syslog server.
4. Click Apply.

Configuring Syslog Message Severity Level

You can configure the minimum severity level of messages that you want to include in Syslog mes-
sages that are generated by the device. The severity levels are described in the following table.
Severity Level
(Highest to Lowest)
Fatal
Alert
Critical
Error
Warning
Notice
Informational
Debug
The specified severity level and all higher severity levels are included in the Syslog message. For
example, if you configure the parameter to Alert , the Syslog includes messages with Alert
severity level and messages with Fatal severity level.
When viewing Syslog messages in the Web interface (see
page 826), each severity level is displayed in a different color.
➢
To configure the minimum message severity level to include in Syslog:
1. Open the Logging Settings page (Troubleshoot menu > Troubleshoot tab > Logging folder >
Logging Settings).
2. From the 'Log Severity Level' [SyslogLogLevel] drop-down list, select the severity level.
3. Click Apply.
Syslog String
EMERG
ALERT
CRIT
ERROR
WARNING
NOTICE
INFO
DEBUG
- 823 -
Mediant 4000 SBC | User's Manual
Description
A panic condition (system is unstable).
A problem has been identified and an
action must be taken immediately.
A problem has been identified that is
critical.
An error has been identified.
An error that might occur if measures
are not taken to prevent it.
An unusual event has occurred.
An operational message.
Debug message.
Viewing Syslog Messages on