AudioCodes Mediant 4000 SBC User Manual page 489

CHAPTER 20 SIP Definitions
Parameter
[CallSetupRules_
QueryTarget]
'Request Key'
request-key
[CallSetupRules_
AttributesToQuery]
■ LDAP: Defines an LDAP server (LDAP Server Group) on which to
perform an LDAP query for a defined key. To configure LDAP
Server Groups, see
■ Dial Plan: Defines a Dial Plan (name) in which to search for a
defined key. To configure Dial Plans, see
■ ENUM: Specifies the ENUM server on which to perform the ENUM
query. The server is specified by IP Interface name (in the IP
Interfaces table). The address of the ENUM server is the address
of the 'Primary DNS' (and optionally, 'Secondary DNS') parameters
that is configured for the specified IP Interface. If you don't specify
an IP Interface or the specified IP Interface does not exist in the IP
Interfaces table, the device uses the OAMP IP Interface.
■ HTTP GET, HTTP POST Query, and HTTP POST Notification:
Defines the HTTP server to where the device sends the HTTP
request. To configure HTTP servers, see
Services on page 247.
To configure the key, use the 'Request Key' parameter (see below).
Defines the key to query.
■ For LDAP, the key string is queried on the LDAP server.
■ For Dial Plans, the key string is searched for in the specified Dial
Plan.
■ For ENUM, the key string is queried on the ENUM server.
■ For HTTP GET and HTTP POST queries, the key string is queried
on the HTTP server.
The valid value is a string of up to 100 characters. Combined strings
and values can be configured like in the Message Manipulations table,
using the '+' operator. Single quotes (') can be used for specifying a
constant string (e.g., '12345').
You can use the built-in syntax editor to help you configure the field.
Click the Editor button located alongside the field to open the Editor,
and then simply follow the on-screen instructions.
Examples:
■ To LDAP query the AD attribute "mobile" that has the value of the
destination user part of the incoming call:
'mobile=' + param.call.dst.user
■ To LDAP query the AD attribute "telephoneNumber" that has a
redirect number:
'telephoneNumber=' + param.call.redirect + '*'
■ To query a Dial Plan for the source number:
param.call.src.user
■ To query an ENUM server for the URI of the called (destination)
number:
- 456 -
Mediant 4000 SBC | User's Manual
Description
Configuring LDAP Server
Configuring Dial
Configuring Remote Web
Groups.
Plans.