CHAPTER 51 Reporting Information to External Party
➢
To configure RTCP XR:
1.
Open the RTP/RTCP Settings page (Setup menu > Signaling & Media tab > Media folder >
RTP/RTCP Settings).
2.
Under the RTCP-XR group, configure the following:
●
'Enable RTCP XR' (VQMonEnable) - enables voice quality monitoring and RTCP XR.
●
'Tx RTCP Packets Interval' (RTCPInterval) - defines the time interval between adjacent
RTCP reports.
●
'Disable RTCP XR Interval Randomization' (DisableRTCPRandomize) - determines
whether RTCP report intervals are randomized or whether each report interval accords
exactly to the parameter RTCPInterval.
●
'Burst Threshold' (VQMonBurstHR) - defines the voice quality monitoring excessive burst
alert threshold.
●
'Delay Threshold' (VQMonDelayTHR) - defines the voice quality monitoring excessive
delay alert threshold.
●
'R-Value Delay Threshold' (VQMonEOCRValTHR) - defines the voice quality monitoring
end of call low quality alert threshold.
●
'Minimum Gap Size' (VQMonGMin) - defines the voice quality monitoring minimum gap
size (number of frames).
3.
Under the RTCP-XR Collection Server group, configure the following:
●
'Publication IP Group ID' (PublicationIPGroupID): Configures the IP Group to where you
want the device to send RTCP XR reports.
●
'SBC RTCP XR Report Mode' (SBCRtcpXrReportMode): Enables the sending of RTCP
XR reports of QoE metrics at the end of each call session (i.e., after a SIP BYE).
- 763 -
Mediant 4000 SBC | User's Manual